Remington 498 Bedienungsanleitung PDF herunterladen (Seite 19)

114915

6. Remove piston assembly from piston sleeve (see Figure 4).

7. Tilt rear of base plate down. Guide will slide out.

B. REMOVING RUBBER PAD

1. Loosen screw on back of rubber pad with 5mm Allen wrench.

2. Detach rubber pad from top of tool ﬁrst, then pull entire rubber pad from tool.

C. REMOVING ROCKER ARM

Rocker arm assembly is located on rubber pad.

1. Push out rocker arm pin (see Figure 6).

2. Remove rocker arm and spring from rubber pad.

Figure 4 - Removing Piston From Piston Sleeve

Figure 5 - Removing Rubber Pad

Rocker Arm

Spring

Figure 6 - Removing Rocker Arm

Piston

Piston Sleeve

Rubber Pad

Rocker Arm Pin

Rubber Pad

Tool Disassembly and

Assembly

5mm Allen Wrench

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 87 88

Keine Kommentare

Remington 498 Bedienungsanleitung Seite 19