Remington IPL2000 Anleitung zur Fehlerbehebung PDF herunterladen (Seite 11)

• Afterreachinglevel3,pressingtheEnergyLevelButtonagainwillresetbacktoenergylevel1.

• Thei-LightREVEALisequippedwith3energylevels.Level1(1bar)isthelowestandlevel3(3bars)

is the highest.

, TIP: For the most eective results, always use the highest energy level that does not cause discomfort

on the skin.

, Test the i-Light REVEAL on your skin

• Before your rst full treatment, test the i-Light REVEAL device on a small patch of skin and wait 24

hours to ensure there are no adverse reactions.

• Startatenergylevel1andashonce.

Flash the skin by placing the ash window rmly against your skin. You will hear a ‘beep beep’ and the

skin tone sensor should show a solid green light. Press the ash button to deliver a ash. Fig. 12

, TIP: It is helpful to use a mirror to see the skin tone sensor. If the reected light is unpleasant, you may

wish to close your eyes before each ash.

• Mildtomoderatediscomfortisnormal.IfaashdeliveredatEnergyLevel1feelstolerable,increaseto

Energy Level 2. Move the device to a dierent spot and ash the i-Light REVEAL one more time.

Repeat this process until you nd the setting that feels right for you.

• Wait24hoursandthenlookatthetestarea.Iftheskinappearsnormal,proceedwithyourrstfull

treatment at that the energy level you determined is right for you.

, NOTE: You must test the device on each area of the face or body you wish to treat.

, Treat desired area(s) with the i-Light device

, Prepare your skin for treatment

1.Ensuretheareatobetreatediscleanandfreefromoils,deodorants,perfume,makeup,lotionsand

creams. Shave or trim the hair from the area to be treated, and ensure the skin is clean and dry. If

trimming; the hair must be trimmed to less than 0.5mm. Fig. 13

Fig. 12

Fig. 13

ENGLISH

EPSK

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 151 152

Keine Kommentare

Remington IPL2000 Anleitung zur Fehlerbehebung Seite 11